Basket

Basket

9V and USB power converters for Eurorack

9V Eurorack Power Converter
(Last Updated On: 07/12/2020)

12V and 9V Eurorack Power Converters

As addition to the DSQ-1 and DR20 the two power converters connect the devices to the 12V Eurorack power supply. It abolishes batteries or external power supplies which are usually used to power the devices.

Easy Connection

USB power converter

Just connect the Eurorack connector to the Eurorack power supply and plug in the USB cable from the Korg SQ-1 (or any other USB powered device)

9V power converter

Disconnect the cables from the RE-20 battery holder and solder them onto the small PCB. (Pay attention to the correct polarity) Although pre-configured to 9V, the converter power can be freely adjusted for other devices to any voltage below 12V.

Order the Power Converter

Each Converter comes with a small housing and ribbon cable. While the USB version is a ready-to-go device, the 9V version requires to solder the power cables from the according device.

http://spillerphoto.com/product/12v-usb-eurorack-power-converter/
http://spillerphoto.com/product/9v-eurorack-power-converter/
2 Replies on

9V and USB power converters for Eurorack

  • Hi there, how much power 12V Eurorack to 9V Power Converter gives? I need at least 150mA.
    Is there any manual how to solder cables?
    Thanks
    AIn

    1. I’m not an electrical expert and I’m using ready made PCBs. The output current is depending on the input current which is fed into the converter.
      Output Current:3A (max),actual testing input 12V output 1.5A. There are only two cables to solder on the input pins of your device. The flat-wire which connects to the Eurorack power rail is already pre-soldered.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.