3D printed cases for the TE Pocket Operators - spillerphoto

3D printed cases for the TE Pocket Operators

I was working on this already several months and today I finally finished the design and prints of four 3D printed cases for the TE Pocket Operators from Teenage Engineering. The cases are in classic synth design and provide a full enclosure for the Pocket Operators.

3D printed Case for TE Pocket Operators

After a lot of wasted trial prints and an almost finished design which went into the waste bin, I finally finished the case with 4 new designs for the TE Pocket Operators. 3D printed cases for TE Pocket Operators in vintage synth design for the Teenage Engineering Pocket Operator is printed with high quality Prusament PLA, Filamentum PLA and or FilaFlex40. The case and button colours are fully configurable.

The ready 3D printed case includes:

  • Top part of the enclosure
  • Bottom part of the enclosure
  • 4 screws
  • 23 buttons
  • 4 silicon feet

Update 01.12.2020:

  • 2 encoder caps

Zurück zum Blog

Hinterlasse einen Kommentar

Bitte beachte, dass Kommentare vor der Veröffentlichung freigegeben werden müssen.