Today I would like to introduce a solution to get the Teenage Engineering Pocket Operators setup better organized on your desk. The Base3 and the BaseLS are base plates on which the upper parts of the cases can be mounted onto. No more sliding around of the Pocket Operators during performance.
Both base plates are printed with high quality Pusa Prusament PLA filament on Prusa i3 MK3s 3D printers.
Base3 for the Pocket Operator Cases
The Base3 consists out of 3 slots for 3 of the 3D printed cases available in the online-shop. The upper part of each 3D printed PO Case is simply screwed onto the base plate. The sync/audio jacks are all free accessible due to the slightly tilted and lifted middle position.
The base plate comes with 6 small silicon feet to ensure a safe and solid stand on the desk.
The Base3 is compatible with all 3D printed PO Cases.
Base3 Photos
BaseLS for 3D printed Pocket Operator cases
The BasePlateLS can accommodate 2 POs plus one JBL GO2 active speaker. The upper part of each PO Case is simply screwed onto the base plate. The JBL GO2 speaker slides into the middle position. All buttons of the JBL speaker as well as the sync/audio jacks are all free accessible.
The base plate comes with 6 small silicon feet to ensure a safe and solid stand on the desk.
The BaseLS is compatible with all 3D printed PO Cases.